![]() To generate the encrypted password, the easiest way is to use OpenSSL on a Raspberry Pi that is already running (or most any linux you have running) – open a terminal window and enter:Įcho ‘mypassword’ | openssl passwd -6 -stdin This file should contain a single line of text, consisting of username:encrypted-password – so your desired username, followed immediately by a colon, followed immediately by an encrypted representation of the password you want to use. To set up a user on first boot on headless, create a file called userconf or userconf.txt in the boot partition of the SD card. The advanced option (cogwheel) will allow you to add both options before writing to SD-card.įor security reasons, as of the spring 2022 release, Raspbian OS no longer has a default pi user wit assigned password. This will currently only work with 64-bit capable Raspberry Pi and Pi OS that is 64-bit.įor the below 2 tasks (user/password and SSH-access) the Raspberry Pi imager can be used as an alternative. Open the rvice file and change the ExecStart line to read /usr/local/bin/node instead of /usr/bin/nodeĬopy the service file and enable it sudo cp /home/pi/plexamp/rvice /lib/systemd/system/plexamp.PlexAmp-installer for Raspberry Pi with ARMv8, 64-bit HW.įor more information and hardware used, see here:Īssumes 64-bit capable Raspberry Pi HW and Pi OS that is 64-bit.Ĭurrently installs/upgrades to: Plexamp-Linux-headless-v4.4.0 Burning the image.īurn the OS-image to the Micro-SD card using Raspberry pi imager, etcher (or app of your choice). Unpack it bunzip2 Plexamp-v2.0.0-rPi-beta.2.tar.bz2 To install, extract it to /usr/local sudo tar -C /usr/local -strip-components=1 -xzf node-v9.11. The NodeJS archive of tarballs is here and for the Pi Zero we want ARM6L version. So we’re going to have to install it manually. The first problem is Plexamp depends on an outdated version of NodeJS 9.11.2, and this version is not available for the Pi Zero in the Debian repository. The official instructions for this are here on the Plex forums, but they’re a little dated. Reboot and test your DAC speaker-test -l5 -c2 -t wav SETTING UP PLEXAMP This step will be specific to your audio DAC or soundcard, but if you bought that same one I linked above you run it’s setup script: sudo wget -O - | bash. Just fill out your WiFi information there at the bottom. Then set up the WiFi connection by creating /boot/wpa_nf with the following: ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev I use Etcher to do this.īefore booting the Pi up I like to go ahead and configure it so I won’t have to connect it to a monitor.Įnable SSH by default by creating an empty file /boot/ssh touch /boot/ssh This is stuff I had laying around in my electronics bin, any Pi with any type of soundcard (whether a hat or USB).įirst step to any Pi project, flash the latest version of Raspberry Pi OS (formerly known as Raspbian). I wanted to be able to stream Plexamp to my hi-fi stereo the same way I do other music, and of course this is a problem that can be solved with a Raspberry Pi. They’ve recently put a lot of effort into the re-vamped Plexamp music player and it’s quickly become my primary means of listening to my music library. I’ve been a Plex user for a very long while.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |